AirTag Keychain

Instructions

After failing a few times at trying to figure out how to build Leon's great look [AirTag keychain](https://hub.shapertools.com/creators/603f5f8592087e0011144d9c/shares/6097f399f226fd001193ca7a) I hacked up this derivative version. On the key chain object drill out the middle circle. Cut down to 0.4 inches the second ring then with an outer cut out the keychain. For the wood cap, you'll want to cut out the entire circle down 0.3 inches leaving a 0.2 inch circle disk left. Do an outer cut of the circle out of the ring down to 0.3 inches. This is to allow space for your bit to engrave the logo on the circle. Engrave and then cut out the rest of the circle. Put in the AirTag metal side first and pop in the wooden cap. If you are afraid of losing your AirTag you can apply some light glue. I'm able to get a good enough fit that I'm leaving it for now. If you want to create your own disk, just create a circle 32mm in diameter and add your own logo. For reference the AirTag dimensions are: - 32mm diameter - 26mm diameter of metal ring - 8mm heigh (5mm white, 3mm metal disk)