AirTag Ring
AirTag Key Holder for the new Apple Airtag You got your new Apple Airtag but don't have the money to buy the expensive accessories? Not a problem! Have fun!
94
Toys
Files Included (2)
Airtag 1.svg
783 BAirtag2.svg
2 kB
Materials
In my example: Oak and Wallnut
could be done with any hard wood and plywood
Tools
Shaper Origin,
Workstation,
3mm router bit,
6mm router bit
Instructions
1. First, cut the top view of the AirTag Ring. You can decide if you want to cut the entire Airtag or maybe only the top side. The entire Ring is 12mm thick. 2. After you did the top part you need to clamp it sideways on the workstation to cut the line where the Airtag fits. I had made this area a little bit bigger so you need to align it to: x = -4 y = 0 with the Anker point in the left bottom corner. 3. Now you only need to sand it and do some finishing. 4. At the end carefully slide your Airtag in. Done