Palm Router Cleat

By mberg | Created September 8th, 2020 | Published September 8th, 2020 | Updated September 8th, 2020

uploaded project imageuploaded project image
project image thumbnailproject image thumbnail
project image thumbnailproject image thumbnail
This designed to fit a Bosch Colt palm router but it can be easily adapted to fit other palm routers.

30 min

Easy

2

Category

Cleats

Files included (3)
NameSize
router-bottom.svg
1 kB
router-cleat-side-a.svg
8 kB

1/2 ply
1/4 and 1/8 bit
Sides - Pocket inner slot to 0.25 inches with a 1/4 bit. Use an inside cut -0.07 inch offset to ensure a snug fit. - Cut out sides. Use 1/8 bit to get deeper into the cleat slot Bottom - Cut out the circle with an inner cut - Pocket out the inner area to 1/4 inch. This will create a nice little hole for the router to rest in Glue up Credits - Adapted from from Shawn's Hand Sanitizer cleat https://hub.shapertools.com/creators/59b9b892291ebbfa71254b52/shares/5e73c7cbce53b3000f11b60f

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license