Systainer3 for Bits, Scraper, Pry Bar - Benchpilot
This is the companion project to the Systainer project I have on Shaper Hub for workstation accessories. It holds quite a number of bits, in their original packaging. I can't deal with having all those unlabeled bits next to each other, having to measure them to see what they are. This solves that. I've also included space for the Shaper scraper, pry bar, and brush.
2
Systainer Inserts
Files Included (1)
Systainer for Bits and Scrapers.svg
439 kB
Materials
Shaper Origin with Benchpilot
New Systainer3
1/4" x 1-3/8" upcutting bit (you could use the one that comes with the Shaper Origin, but I think this is easier)
Double sided tape (although I found countersinking screws from the jigs to the workstation extended table worked better.
Shapertape
Shelf Upgrade Kit
Extended Workstation Table (made from Shaper Hub design and 16"x22" 1/2" MDF (if not already prepared for accessory storage project)
Additional 16"x22"x1/2" MDF for jig.
Tools
Shaper Origin
Benchpilot
Instructions
I also built a 16" x 22" large workstation table to allow cutting with Benchpilot. This allows more Shapertape and more surface for the Benchpilot to lean over. Frankly, I can't imagine doing all these cuts without the Benchpilot. Much better this way, though the dimensions will work without Benchpilot. I countersunk some screws from the jig into the extended workstation table, as this made sure it didn't move between tests. Double sided tape might also work, but I was sure this would. I centered all of the files at the position x=11, y=9.5 This allowed the Benchpilot to fully reach the design.