New Shaper Workstation Accessories Kit Benchpilot
I made a jig and modified the file from the Shaper Workstation Accessories Kit A, as the shape of the new Systainer has changed, and the old files won't work correctly with it.
5
Systainer Inserts
Files Included (2)
Systainer New Shape - Accessories with B Wrench.svg
203 kBSystainer New Shape - Bottom Foam.svg
15 kB
Materials
2x4 1/2" MDF
New Shaper Systainer
The foam inserts included with the Systainer
Tools
Shaper Origin with Benchpilot
1/4" x 1-3/8" upcutting bit (you could use the one that comes with the Shaper Origin, but I think this is easier)
Double sided tape (although I found countersinking screws from the jigs to the workstation extended table worked better.
Shapertape
Shelf Upgrade Kit
Extended Workstation Table (made from Shaper Hub design and 16"x22" 1/2" MDF)
Instructions
I also built a 16" x 22" large workstation table to allow cutting with Benchpilot. This allows more Shapertape and more surface for the Benchpilot to lean over. Frankly, I can't imagine doing all these cuts without the Benchpilot. Much better this way, though the dimensions will work without Benchpilot. I countersunk some screws from the jig into the extended workstation table, as this made sure it didn't move between tests. Double sided tape might also work, but I was sure this would. To get the Systainer to close with full roles of tape you need to cut the bottom foam too. Those don't need to be full height cuts. I kept them at 55mm height. I had wrench design B, so that's what this design uses. I centered all of the files at the position x=11, y=9.5 This allowed the Benchpilot to fully reach the design.