Coffee table

|
|
Updated Sun Nov 24 2024

A coffee table made for my sister. I designed it quickly on sketchup. I finished the whole project in 2 days (not 2 full days) I would definitely widen the legs

> 2 hr
Easy

3

Furniture

Files Included (3)

  • table leg tenon.svg

    2 kB
  • table low dogbones.svg

    5 kB
  • Table top.svg

    10 kB

Materials

Rubber wood 18mm thick

Table top 980x794 mm

table low 749x620 mm

leg tenon 150x18 mm -3 pieces

Tools

Shaper origin

8mm straight flute, using autopass.

Lamello zeta P2 with tenso p14

Instructions

You can easily modify the table height- as you must cut the legs to the height you want Legs are 150mm wide on 18mm thick. I cut 3 pieces 390mmx150mm out of 18mm rubber wood I made the tenons 19mm to sand it evenly with the table top. Once I had all my pieces I determined the lower table height and used the zeta p2 with clamex tenso P14 to attach everything together. Then I put some glue on the tenons and put the table top. In the end I added small transparent silicon stands below the legs and it significan,tly improved the stability(see picture) As this was my very first try, I would advise to make the legs 3 to 5 cm wider, thus increasing stablity. But then, you 'll have to redesign the lower part of the table. Also, instead of using the lamello, I would also use half way tenons in the legs, but then, it'll require more thought design-wise. I rounded the edges with the router. Initially, I intended to round the top edge and chamfrein the lower edge. AS I rouned the wrong face of my table first, I ended up rounding both sides of the plate....


Made by Shaper Tools

© ShaperHub & Shaper Tools, Inc. all rights reserved