Bottle Opener
Here is my take on a bottle opener. I realized after the fact that there seems to be a few of this already published on here, but here's another.
12
Kitchen
Files Included (6)
Bottle Opener Drawing.pdf
37 kBBottle Opener Handle Bottom Side Step 2.svg
3 kBBottle Opener Handle Bottom Side Step 3.svg
1 kBBottle Opener Handle Bottom Side Step 4.svg
6 kBBottle Opener Handle Top Side Step 1.svg
8 kBBottle Opener Instructions.pdf
655 kB
Materials
• 2.25” x 7” (or 14” if making two) x ¾” to 1” thick hardwood.
• Epoxy Resin (I used Total Boat)
• Black Epoxy Dye
• Metal bottle opener insert (purchased)
• 6mm x 2mm Neodymium magnets (purchased)
Links to the purchased parts are included in the detailed instructions in the files section.
Tools
• Shaper Origin
• Shaper Workstation (or comparable home-made device), along with an appropriate extension table made to support a 14” wide board. (I made one out of MDF, which was about 16” x 12”)
• ¼” x ¾” Router Bit (should have been included with your Shaper Origin)
• 1/8” x ½” Router Bit
• 1/16” x ½” Router Bit
• ½” x 1” Router Bit
• ½” Core Box Router Bit
• 1/8” or 3/16” Round Over Router Bit (to be used on router table)
Instructions
Detailed instructions are included in the files section as a PDF. All SVG files are included along with a drawing which is handy for referring to for cut depths.