Spokeshave Holder
Wall-mounted spoke shave holder for three tools.
6
Storage & Organization
Files Included (1)
spokeshave holder.dxf
133 kB
Materials
50x175mm stock for each of the two brackets. I used 18mm maple, but even 12mm plywood would work too- chef's choice.
Tools
Shaper Origin, Palm router with round over bit, drill or drill press.
Instructions
I didn't see any spokeshave holders on Shaper Hub, and after seeing Aspen Golan's in her masterclass videos, I wanted one too. So here's my design. Will fit three tools, and I chose to angle the two pieces for smaller spokeshaves on top. Pretty straightforward: Cut out shape (I did two roughing passes with 5mm o-flute at 1mm offset, then finish pass with 8mm 3-flute) Drill holes (I used drill press with 1/2" forstner for screw head recess, then 3/16" for through hole) Roundover edges (I used a 1/8" round over bit in a palm router) Sand & Finish (clearly, I didn't do this judging from my photos!)