French cleatify your Bosch e-bike charger
Hang my Bosch e-bike charger to my french cleat.
1 hr
Easy
10
Cleats
Files Included (1)
bosch-ebike-charger-holder-french-cleat-200x113.svg
2 kB
Materials
I used 18mm thick plywood.
two pieces of 200x113 mm (will be cut with Origin)
one rectangular piece of 200x67 mm (uncut)
Tools
Shaper Origin
(Optional) Edge router
(Optional) Countersink bit / drill
Instructions
Use the svg to cut two sides of the holder: one as is and the second one in mirror. Make the (open) pocket 10mm deep. Cut the rest out. Optionally countersink the edge of the screw holes from the outside. Optionally edge route every piece. Then screw the rectangular piece of 200x67 cm in between the two sides, on the back. Hang the holder on your french cleat. You can now slide in your charger!