Small Christmas tree decoration
This was my first test run of the shaper origin for a full cut on the day I received it. I ran through the setup, engraved one of the included states on the USB stick, then decided to test my own EPS/SWG file. It came out ok for a test run.
10 min
Easy
17
Decor
Files Included (1)
christmastree-outline.svg
1 kB
Materials
1/2 plywood or whatever suits you
Tools
Shaper Origin with 1/8 bit
Instructions
I personally made an inside offset run by .2 at .125 depth then an outside offset by .1 to create a lip for the tree, but it can be run however you like. A straight run around the tree with 2 passes at .25 then .51 to cut all the way through should give decent results. I had the speed set to 6.