Systainers drawer 750mm full extension
Based on Nelson's original systainer drawer, with added circle detail on the handle and dimensioned for my project.
23
Storage & Organization
Files Included (1)
systainer_drawer_2deep_rh.svg
4 kB
Materials
750x398.6x8 mm for the template
750x398.6x19 mm for the drawer
Tools
6mm router bit for Shaper Origin
Copying router bit and forstner drill bit and double sided tape if you use the template
Instructions
You can either cut the drawer directly with Shaper Origin, or create a template and copy it. I used 8mm Trespa panel for the template which is a HPL panel, quite tough to cut, but that should make a very durable template. Used the 6mm shaper bit to route everything. Then attached the template to 19mm MDF with Shaper's double sided tape, pre-drilled the pockets to allow my copying bit to fit and copied the template. After that I added a small roundover on the handle and front of the drawer. Note: The drawers are 398.6 mm of width, because I based my workbench on the SYS-AZ dimensions (425mm of width). I substracted the width of my drawer slides (2x12.7mm), and 1 mm to have some slack ...