Bottle Opener SVG

Instructions

I created an SVG in Shaper Labs out of shapes, so this is not perfect but gets the job done. I use the Shaper Origin 1/4” Up-Spiral Router Bit. Circle 1. Pocket out Circle at .08mm or deeper if you want to account for bigger screws. Some find the screws provided to be too small so the heads do not sit flush if using larger #4s. 2. Inside Cut pass with 0 offset to finish circle. Middle Shape 1. Pocket .40mm. I take a .25mm pass first then the full .40mm. 2. Inside Line Offset to Clean up at -.03. This is important because the shape isn't perfect and you need this to create enough gap so the bottle top can grab the side. Here is the Amazon link for these particular bottle openers. https://www.amazon.com/gp/product/B087CN7WG3/ref=ppx_yo_dt_b_asin_title_o08_s00?ie=UTF8&psc=1