Mexican Train Domino Game

Instructions

a- make five "plates" of maple that are about 4-1/2 x 16-1/2 x 3/8". This was a convenient size to allow use of shaper work station as the holder. note that there are 5 SVG files that make up all the domino dot patterns. b -use SO to cut the domino dot pattern c - fill dots on dominos with each epoxy color that corresponds to that number in the dot pattern. d - plane down the excess epoxy on each plate e - use the SO to cut out the dominos f - I made a jig (with the SO) that I used to hold the small dominos while I ran each edge through the round over bit on the router table. g - Sand dominos, and more sand. h - use SO to cut out center hub i - use SO to cut a "stick" of the train tokens in one side. j - fill the train tokens on the one side that were just cut with each color of the epoxy. k - plane the excess epoxy off the one side of the train token "stick" l - repeat steps i, j, and k to complete other three side of train "stick" m - make a box to hold game pieces.