Milwaukee 23 gauge M12 pin nailer French cleats
I recently purchased a Milwaukee 23 gauge M12 cordless pin nailer. I made a French cleat holder for it. Works well, the tool is very accessible It's based on French cleats I found on Shaper Hub, I modified it using Studio.
10 min
Easy
5
Cleats
Files Included (1)
m-12-23-gauge-pin-nailer-cleats.svg
11 kB
Materials
3/4" baltic birch plywood
Tools
1/4" bit
Instructions
Easy to cut. The recesses that the nailer sits in were a little small. I had to sand them to be wider/deeper to fit the nailer. The support piece between the two cleats is about 1 1/2" x 1 3/4". It's glued and nailed (using the pin nailer, of course).