Bottle opener
By Fritz3|BY-NC-SA 4.0 License|Updated December 29th, 2022
Found a piece of steel for an opener on Amazon, which already was shown in ShaperHub.
I wanted to equip it with a handle. So I made a few.
10 min
Easy
11
Files included (1)
Hard wood, allowing 60mm diameter, 18 to 30mm thick
Steel has 39mm diameter
Shaper Origin,
Router bit 6mm
Shaper Workstation
Lathe for turning the handle (optional)
Used Shaper Origing and workstation to make the head, made a handle with the lathe and drilled a hole to insert the handle.
Made two samples without a handle, because the knob cut out with the router gives enough grip to open a bottle.
Use min. 8mm cutting depth for the cut out, can be more, depending on your choice of wood.
In the SVG file you find the tolerances I found, might be different! So start with 39mm and add some negative offset to enlarge, until the piece of steel fits.