Plywood Reindeer

Instructions

Not sure why but Shaper may want to do these cuts as online…make sure you switch them to pocket with an offset of -.05” or else you won’t get a toolpath. I’ve sized the joints to work with 5/8” plywood. The joints are a little looser than I had intended but should tighten up slightly once painted. I painted mine using a brush and a roller with some exterior acrylic white paint. I’ve sized each deer pattern to fit on a half sheet of plywood. Because there was space left in the patterns, I’ve added in the bottom 4” of each leg twice to allow you to glue onto each leg which will strengthen them up if you want to secure the deer to the ground. You’ll also need a jigsaw to finish cutting these out. All parts are bridged to the material you’re cutting out of so that they don’t need to be taped to a backer board in order for the cutting to be completed. Forgive me as the files aren’t perfect but this is the first real drawing I’ve put together. Enjoy!