This is a wheel base for a cyclone dust separator. It comes standard with three casters that bolt to the bottom of the bucket but that was very unstable. I made this to hold the bucket lower to the ground (with adjustability), a wider stance, and four wheels instead of three.
19
Jigs & Fixtures
square cart.svg
13” x 13” 3/4” plywood
(4) casters
(1) dust cyclone
(4) 5/16-18 T-nuts
(4) 5/16-18 nuts
Casters (4): https://www.homedepot.com/p/Everbilt-2-in-Hard-Rubber-Threaded-Stem-Casters-with-80-lb-Load-Rating-2-per-Pack-49344/203661048?
Dust cyclone (1):
https://www.oneida-air.com/dust-deputy/wet-dry-vacuum-kits/dust-deputy-deluxe-cyclone-separator-kit
T-Nuts (4):
Shaper Origin
Hammer
Wrench
After assembling the bottom of the wood is around 2-1/2” from the bottom of the bucket. You can modify this by making the hole slightly smaller with an offset. I added some danish oil to the wood to help protect it.
Made by Shaper Tools
© ShaperHub & Shaper Tools, Inc. all rights reserved