Teardrop Camper Ventilation
Templates for cutting a Kay Enterprises LLC (D-BParts) Camper / Trailer low profile Popup Aluminum vent with gasket and Trim Ring The templates is designed for use with a router equipped with a 10.8 mm copying ring and a 5 mm router bit Can be used on vertical and horizontal surfaces
0
Jigs & Fixtures
Files Included (2)
indvendig_1.svg
68 kBudvendig_1.svg
86 kB
Materials
8 mm Valchromat, Plywood or simulare
Tools
3 or 5 mm bit
Shaper Workstation or ShaperTape
Double sided tape
Instructions
Please note that there is a difference between the exterior (ext) and interior (int) templates Mount the exterior template with some double-sided tape, drill 4 through holes, and mount the interior template with through screws as shown in the picture The two templates should now be aligned with each other After routing, individually rotate the templates 180 degrees (upside down) for a clean cut of the three tabs with the router Enjoy