Small display stand with VESA 75 mount
Small display stand with VESA 75 mount for 10-12" displays
13
Electronics
Files Included (2)
display_stand_vesa75_board_1.svg
11 kBdisplay_stand_vesa75_board_2.svg
5 kB
Materials
2x IKEA APTITLIG cutting boards or any other 1x 12mm wooden board
1x M6 screw 45mm
4x M4 10mm screws to hold the display
Washers
1x M6 T-Nut (Einschlagmutter) or if you can't get one a normal M6 Nut
sanding paper
wood oil
Tools
SO
1/8" or 3mm spiral upcut router bit smaller than 4mm
sanding paper
wood oil
Instructions
Since I used two IKEA cutting boards as material, I arranged the parts so they would fit nicely. Use any router bit smaller than 4mm (I used 1/8" / 3,175mm) or otherwise you won't be able to cut the dogbones (4mm). The pockets can be done as an inside cut with 0.1mm offset. I just drew them as pockets to remind myself to use an offset for a better fit. I'd recommend to round the back of the knob like shown in the picture, makes fastening much easier. If you can't get a T-Nut you could use the hexagonal pocket from the knob and exchange the T-Nut pocket in one of the arms for it and use a normal nut. The two small holes in the VESA mount are for optional screws. I glued everything together and did not need them. Cut all holes and pockets with spiral cut.