UJK MFT Backstop

By MuteMan | Created July 14th, 2020 | Published July 14th, 2020 | Updated July 14th, 2020

uploaded project imageuploaded project image
project image thumbnailproject image thumbnail
project image thumbnailproject image thumbnail
UJK MFT backstops are 18mm thick. This project will allow you to make a version from thinner material. This design works at 90 & 45 degrees.

10 min

Easy

6

Category

Jigs & Fixtures

Files included (1)
NameSize
MFT Backstop.svg
2 kB

6mm cutter Engraving cutter
Holes are 20mm use a -0.1mm offset for a snug fit. Engraving cutter used on the line around the holes for a small chamfer.

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license