Accessories holder

By Xack | Created July 18th, 2020 | Published July 18th, 2020 | Updated July 18th, 2020

uploaded project imageuploaded project image
project image thumbnailproject image thumbnail
project image thumbnailproject image thumbnail
It is just a little device that helps to keep the most used tool for origin in place in the systainer. You can use almost every 3D-printer to print it. It is smaller than 200mm so you can use even a very small printer. Attached you will find the necessary STL-file. If you print it with the open slots down, in most cases support material is not necessary. On my printer it took around 3h to print.

20 min

Easy

8

Category

Systainer Inserts

Files included (2)
NameSize
Accessories-holder.stl
67 kB
Accessories-holder.step
77 kB

- PETG or PLA Material for 3D-Printers - Double sided adhesive tape
3D-printer
Download the Accessories-holder.stl file. Import it into your favourite slicer software. Place the part with the slots down on the printer bed. In most cases additional support material is not necessary. Generate the gcode for your 3D-Printer. Run the generated gcode on your printer. On my printer it took around 3h to print. You can fix it in the systainer with double sided adhesive tape. I attached the STEP-file Accessories-holder.step as well so you can modify the 3D-model according to your needs with almost every 3D CAD-system.

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license