Garage Tool Holder
A simple tool holder for the garage.
20 min
Easy
6
Storage & Organization
Files Included (1)
garage-tool-rack.svg
3 kB
Materials
(2) pieces of 1x6 (nominally 0.75"x5.5"), whatever length you desire.
(8) 4" screws
Tools
Shaper Origin, Plate, and 1/4" bit.
Drill with 1/8" drill bit
Instructions
Scan Plate, and make a grid with the (0,0) point centered left/right and up against the extended bottom fence. Place the design in this space with the board going left/right. I marked 9" centers for each slot. Then use Plate to cut. The screws go through the back of the slots. Use the 1/8" drill bit to make a pilot hole from the back side of the holder to the back of the slots, then start the screws in the hole. Mount the holder a stud, then do the same for the other. Finally, enjoy the racking of all your tools.