Shaper Systainer Kit Created by James_W — Another Systainer insert layout. This one allows for twelve 1/4" bits (with a cut out for 4 specialty bits) and ten 1/8" bits. It also has a cut-out for needle-nosed tweezers, a detail sander, and a "utility pocket."
For instructions, refer to Sam's video.
Another Systainer insert layout. This one allows for twelve 1/4" bits (with a cut out for 4 specialty bits) and ten 1/8" bits. It also has a cut-out for needle-nosed tweezers, a detail sander, and a "utility pocket."
For instructions, refer to Sam's video.
24" x 24" plywood (1)
2" x 4" (1.5" x 3.5") (2)
Shaper Tape
2-sided tape
Shaper Origin
1/4" cutter
1/8" cutter
1/32" cutter (for needle-nose tweezer cut-out)
a 1/16" cutter is helpful for some of the radii, but not necessary.