Orbital Sander French Cleat

By AggieDadFM | Created February 16th, 2020 | Published February 16th, 2020 | Updated February 16th, 2020

uploaded project image
project image thumbnail
project image thumbnail
This is a neat little shelf for holding orbital and mouse sanders.

20 min

Easy

3

Category

Cleats

Files included (1)
NameSize
Sander Rack.svg
1 kB

- 1/2 inch plywood - Shaper Tape
- Shaper Origin
The file contains one side shelf (you’ll need to duplicate it and cut the opposite side) and the lower and back braces. For this project I experimented by choosing to not build my corner circles into my SVG file, and created them on the fly using the Design tool in SO. It took a little longer, but it was fun. You can choose to add them if you want. I ended up using a -0.01 offset to get a snug (but not super tight) fit.

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license