Small right angle clamping jig
Miniature version of a welder's corner brace. Needed two of these for a small project made of copper clad FR4. Used to hold two pieces at right angles while I added a bead of solder down the joint. Checked them after cutting out with a good Starret machinist square and they were darn square (technical term). Made from 1/2" MDF, cut out with 1/4" spiral bit.
20 min
Easy
45
Jigs & Fixtures
Files Included (1)
right angle clamp.svg
1 kB
Materials
scraps of 1/2" MDF
Tools
Shaper Origin
1/4" spiral bit (up- or down-cut)
Instructions
Due to the size of the parts, make sure the stock is well secured to the spoil board with doubled sided tape or add a couple of tabs on the final pass.