Makita Charger Wall Mount Cleat

By Misternick808 | Created October 9th, 2020 | Published October 9th, 2020 | Updated October 9th, 2020

uploaded project imageuploaded project image
project image thumbnailproject image thumbnail
project image thumbnailproject image thumbnail
project image thumbnailproject image thumbnail
project image thumbnailproject image thumbnail
A simple way to mount your Makita battery charger to the wall if you're using cleats. This fits the two-battery rapid charger. Good Luck.

20 min

Easy

1

Category

Storage & Organization

Files included (1)
NameSize
makita charger cleat.svg
1 kB

2 pieces of 3/4 Plywood scrap at least 5" x 10"
Shaper Origin Workstation Mounting tape
I used two pieces of 3/4 scrap plywood that I cut the pattern on the workstation. The pieces are friction fitted to the two sides of the charger using the rubber feet on the bottom of the charger for a tight fit. Place the rubber feet of the charger onto the inside of the mount then swing it in so the charger fits snug. Enjoy! Aloha!

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license