Extension Cord/Cable/Hose Carrying Handle

By Mecworks | Created August 28th, 2020 | Published September 1st, 2020 | Updated September 2nd, 2020

uploaded project imageuploaded project image
project image thumbnailproject image thumbnail
project image thumbnailproject image thumbnail
project image thumbnailproject image thumbnail
project image thumbnailproject image thumbnail
This is based on the 3M Scotch 3781 Handle Strap which has been discontinued. It's an incredibly useful strap for extension cords, hoses and other items. Once they discontinued the handle, I decided to make my own. It's a simple design and works well. This is an easy project and you can make several in about an hour's time (excluding finishing time). https://community.shapertools.com/t/hook-and-loop-extension-cord-cable-hose-carrying-and-storage-handle/5449

10 min

Easy

7

Category

Storage & Organization

Files included (2)
NameSize
Hook & Loop Handle Cord Wrap 1.2.svg
6 kB
Build Instructions v1.1.pdf
5 MB

* 18mm birch void-free hardwood plywood * 36" long 1" wide, reusable Hook & Loop strip * BSI IC-2000 rubber toughened cyanoacrylate glue * CA glue accelerator
Shaper Origin 1/4" bit 1/8" bit Table Router 1/4" round over bit 1/8" miniature round over bit
The build instructions are fairly simple. There are detailed pictures and directions in the Build Instructions PDF file. Ongoing discussion of this project can be found here: https://community.shapertools.com/t/hook-and-loop-extension-cord-cable-hose-carrying-and-storage-handle/5449

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license