Re work of the Shaper Origin Tool kit to fit into a mini Systainer Created by Nick5 — I figured that seen as in origin came in a systainer it was only right its tool had the benefit of a systainer
I re worked the already available tool kit done by shaper tools to fit nicely in the systainer insert I designed
I figured that seen as in origin came in a systainer it was only right its tool had the benefit of a systainer
I re worked the already available tool kit done by shaper tools to fit nicely in the systainer insert I designed
300mmx200mm polyethylene (closed cell foam)I used some 50mm left overs I had but 40mm would be a better option
shaper origin
tape board at the same co planer
6mm/1/4 inch up cut cutter
double sided tape
Vacuum
cut the inside lines of the tools
then pocket at each required tool depth
for the spanner in would offset it by 4mm for a more snug fit
cut the systainer profile out at the end on an outside cut
its a really nice snug fit into the systainer so no need yo offset the release cut