Happiness is homemade inlay

By James52 | Created September 20th, 2020 | Published September 20th, 2020 | Updated September 20th, 2020

uploaded project imageuploaded project image
project image thumbnailproject image thumbnail
project image thumbnailproject image thumbnail
My first inlay project done on a 2.5" thick walnut butcher block. The inlay wood is cherry. If you look at the "a" in happiness you can see I cut on the wrong side of the line. Make sure you pay attention all the way through!:)

2 hr





Files included (4)
Full Pocket - Copy.svg
23 kB
Happiness is insert - Copy.svg
21 kB

1/4" bit 1/8"bit Glue Wood of choice
The cutting files are attached. Just make sure you cut on the correct side of the line;)

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license