1/4'' plywood for the frame (4ft x ~2ft)
1/8'' mdf? for the separators
SO with provided 1/8'' and 1/4'' bits
Edge router with 1/16'' corner round bit for clean edges Router table for front rabbet
- Materials thicknesses and separator height are parameters in the f3d file. ~5'' high separators are used.
- A -0.005'' margin is used for the holes and 1/8'' dado.
- The middle section is made of 2 pieces. The front needs to extruded for the systainer spine. I use a track saw, a router table would have been more suitable.
- Assembly is done inside the systainer, no glue necessary: base, middle, then side and middle frame.
- Separators width is 6 13/16''.