Charcuterie Board

By Stilwell | Created December 18th, 2019 | Published December 18th, 2019 | Updated December 18th, 2019

uploaded project image
project image thumbnail
project image thumbnail
A very long (40") charcuterie board for the holiday gatherings with decorated handles.

20 min





Files included (1)
Charcoutterie Board for mom.svg
12 kB

-Hardwood -sandpaper -food safe finish -1/4" cutter -Engraving bit
The setup for this piece is a little different because I milled my stock to size first and then used Origin to cut and engrave both edges. My stock is 7 7/8" wide and I wanted my cut path to extend off of each side of the board. In the file you'll see two blue 0.25" guide squares on either side. These are used for placement after I made a 0.25" grid. Then I placed the file at x=-0.25" y=+0.25".

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license