Systainer Drawer 2-Deep

Instructions

2-Deep version of the drawer created by Nelson (Thanks for that!). I find it easier to cut out a 1/4 MDF template. For using it, since i only have a top bearing trim bit of a certain size, I connect the template with two screws, and use a fostner bit to drill holes where the feet of the systainer go to make clearance for my bit. Depending how you go about making them this might not be an issue for you (Thicker template, smaller flush trim bit, fresh off the Shaper, etc) For reference, i used GS.4260.28 from Custom Service Hardware (https://www.cshardware.com/gs-4260.html). It's the 700mm length. Holds Shaper and domino XL no problem.