Dyson Vacuum Stand
By Prof_Snipe|BY-NC-SA 4.0 License|Updated June 23rd, 2020
Stand for dyson cordless vacuums including two accessories. Should work on models V8-V11.
1 hr 30 min
Easy
16
Files included (1)
Wood of your choice, approximately 12x64" or larger (to allow shaper some space), 3/4" thick
3/8" dowels
Glue and finish of your choice
3/8" drill bit for drilling the matching dowel holes
If using wood other than 3/4" thick, you may need to adjust the location of the dowel holes.
1. Cut the parts using origin.
2. Drill the dowel holes on the matching pieces. The bottom and top plates align to the front and the two accessory holders align to the back. The stand long arms have a 1/2 degree slant and is narrower at the top.
3. Glue the project together then finish.
4. Attach the vacuum holder to the top plate using the provided screws.