Systainer Classic I, II and III insert template Created by Stevo_Drevo — This template fits Systainer Classic sizes I, II and III.
It does not fit size IV!
Tested on Classic Systainers:
Makita (sizes I, II, III and IV)
Metabo (size II)
Lux Tools Tanos (sizes I, II and III)
Use it as a base for your tool organisation. Please share your creations.
https://youtu.be/14AWZvlWPsA
This template fits Systainer Classic sizes I, II and III.
It does not fit size IV!
Tested on Classic Systainers:
Makita (sizes I, II, III and IV)
Metabo (size II)
Lux Tools Tanos (sizes I, II and III)
Use it as a base for your tool organisation. Please share your creations.
https://youtu.be/14AWZvlWPsA
Load to your Shaper Origin and cut.
I used 6,25mm (1/4") cutter. Did 4 passes - 3mm, 6mm, 9mm and 10,5mm. First three passes were offset by 0,2mm. Fourth was direct on line.
The holes in the middle are just for fingers to get the insert out easily, while testing.