millennium Falcon serving tray

By Brent_Meixell | Created July 30th, 2020 | Published July 30th, 2020 | Updated July 30th, 2020

uploaded project imageuploaded project image
project image thumbnailproject image thumbnail
project image thumbnailproject image thumbnail
Serving tray one side, cutting board the other

1 hr 30 min

Intermediate

1

Category

Kitchen

Files included (1)
NameSize
falcon.svg
10 kB

Maple and Cherry glue
Shaper Origin. table saw.
I started by making strips of wood and gluing them up into TWO sheets. I went with two so that I did not have to do a large pocket and remove so much material. on one sheet you will cut all the way through all profiles. on the second sheet I opted to do a shallow pocket but this project will go faster if you only do an outside profile for the second one and then this becomes the bottom. do your best to Glue the two parts together to align the profile. potential to add alignment dowels in the future, or oversize the outside profile of one and come back with a flush cut router bit.

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license