Christmas Ornament

By dwjohnk | Created December 19th, 2019 | Published December 19th, 2019 | Updated December 20th, 2019

uploaded project image
project image thumbnail
Quick Christmas ornaments

10 min

Easy

4

Category

Decor

Files included (1)
NameSize
puppy paw ornament.svg
38 kB

Any material of your choice. I used 1/2" thick pine and artificial flooring.
Shaper Origin 1/4" carbide router bit
Easy Christmas ornaments. Bottom two on the picture are unfinished. Top two made from artificial flooring with rubber backing (make great coasters). Recommend masking the top before routing the paw prints. That way you can paint then remove the masking tape. Original idea was to put the picture of a deceased pet on the back, but couldn't stop at just one. Update ... I thought a little more on this project: you could 1) pre-finish it, 2) mask the top, 3) route the paw print, 4) paint the paw print, then 5) remove the mask. I didn't do this but in retrospect, it would make the project even easier.

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license