Catan Piece Holder

By tehumbert | Created September 10th, 2018 | Published September 10th, 2018

uploaded project image
project image thumbnail
Cut out a game piece holder for Settlers of Catan.

30 min





Files included (1)
11 kB

24" x 24" x 1/8" sheet of plywood. Spray Paint to match pieces
Shaper Origin
Hexagons fit into the board box. Check out fusion file to verify dimensions. You might have to add more tolerances or offsets to have your pieces fit. This was a fun project, but ultimately it's not the most practical for game setup and storage. Bit: Preferred 1/ 16" upspiral bit or 1/8" should work if you do some corner filing. Depth depends on material thickness. Be careful not to go too deep. Remember to cut the inside out first, use double-sided tape and then cut out the whole piece.

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license