Fancy Feast Dispenser

Instructions

Cut List: 1x Bottom Panel 4x Divider 2x End Panel 1x Mid Panel 2x Side Panel All dado joints assume a nominal plywood thickness, so it is worth measuring your material and then adjusting the cut offset on-tool before making any of the slots. I found that aiming for a loose but not sloppy fit resulted in a good overall glue-up. After cutting, glue all the pieces together with wood glue and clamps. Finally, use a trim router to put a chamfer on all of the edges. Usage: Fill the dispenser with Fancy Feast cans, faced downwards. To remove a can from the dispenser, simply grab it by the rim and pull down and out. Note: I found online some nice SVGs of various fish and mammals to engrave on the side panels just above the openings for each can. This could make for a nice embellishment for your own project.